This document describes how to configure a Paradigm operator interface
terminal to allow communications with a Mitsubishi drive supporting MELSERVO
communications. The protocol supports access to pertinent parameters. Please
read this document carefully before attempting to configure communications with
these devices.
MITSUBISHI MELSERVO
Introduction
The EDICT-97 configuration software has been designed to allow the user to enter
commands in a manner that should be familiar to the user of a drive using MELSERVO.
Addressing Drives
The default drive address, found in Comms Devices, is 0. 0-9 and A-V are the permitted
ranges for Device Addresses.
Communications Mode
The default configuration for Edict97 is:
Port 2 - RS-232
9600 baud
8 bits
Even Parity
1 Stop Bit
If parameter writes are to be performed, it will usually be necessary to write a value to the
BLK parameter in order to enable the appropriate range. These values are:
Free Mitsubishi MELSERVO Manual PDF
Get the file Download here | PDF-HOME